Dupont Delrin is the best plastic for turning on a lathe lathe. It’s easy to turn, however it requires slower speeds. I’ve usedII have used this stuff to make Scottish small pipes chanters. I have bought numerous items from iPlastic. Smaller parts usually ship promptly and everything was well packed. I’ve never had a problem with an order. Dupont Delrin is the perfect plastic for turning on a CNC lathe lathe. It is easy to turn, but it does require slower speeds. I’ve usedII have used this material to make Scottish small pipes chanters. I have purchased many items from iPlastic. Small pieces usually ship promptly and everything has been well packed. I have never had an issue with an order. Between the Delrin and Acetal rods, both materials are very tough and easily machinable, and they have similar POM-C Acetal Sheet physical properties. They do look similar, but in practical uses there are a few differences that can make one better than the other. It also depends heavily on your application. As with any plastic materials, be sure to check the typical properties data sheet for the applicable properties you may require for your application.
0 Comments
Leave a Reply. |