Dupont Delrin is the best plastic for turning on a machine lathe. It’s simple to turn, but it requires slower speeds. I use this stuff to make Scottish small pipes chanters. I have purchased numerous items from iPlastic. The smaller parts always ship promptly and everything was well packed. I have never had a problem with an order. Dupont Delrin is the best plastic for turning on a machine lathe. It’s very easy to turn, however it requires slower speeds. I use this material to make Scottish small pipes chanters. I have bought many items from iPlastic. Smaller parts usually ship promptly and everything has been well packed. I have never had a problem with an order. Between the Delrin and POM-C rods, both materials are exceptionally tough and easily machinable, as they have similar physical properties. They do look the same, but for practical uses there are a few differences that can make one better than the other. It also depends heavily on your application. As with all plastic materials, be sure to check the typical properties Acetal Copolymer data sheet for the appropriate properties you may require for your application.
0 Comments
Leave a Reply. |